From b7c53969180078fd7a6a4a8b98465bfdbe52185b Mon Sep 17 00:00:00 2001 From: lawgicau Date: Sun, 30 Aug 2020 13:35:25 +1000 Subject: [PATCH] Tidy extra restart distance in forms --- calibration.html | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-) diff --git a/calibration.html b/calibration.html index b21721a..2fafb93 100644 --- a/calibration.html +++ b/calibration.html @@ -225,10 +225,10 @@

Retraction

-

If you don't know what to enter here, you can leave the retraction speed at 40 mm/sec. For a bowden tube printer, 6mm is a likely retraction distance. For direct drive, a starting value of 1mm may be suitable.

+

If you don't know what to enter here, you can leave the retraction speed at 40 mm/sec. For a bowden tube printer, 6mm is a likely retraction distance. For direct drive, a starting value of 1mm may be suitable. If you are not sure about extra restart distance, leave this as 0.

-
-


+ +

@@ -304,10 +304,10 @@

Retraction

-

If you don't know what to enter here, you can leave the retraction speed at 40 mm/sec. For a bowden tube printer, 6mm is a likely retraction distance. For direct drive, a starting value of 1mm may be suitable.

+

If you don't know what to enter here, you can leave the retraction speed at 40 mm/sec. For a bowden tube printer, 6mm is a likely retraction distance. For direct drive, a starting value of 1mm may be suitable. If you are not sure about extra restart distance, leave this as 0.

-
-


+ +

@@ -891,8 +891,8 @@

Retraction

For initial tests, you can leave the retraction speed at 40 mm/sec. For a bowden tube printer, 6mm is a likely retraction distance. For direct drive, a starting value of 1mm may be suitable. If you are following this guide in order, you should already know your ideal retraction values.

-
-


+ +

Hot end temperature

Typically, filament comes with a recommended hot end temperature. It is recommended to use values either side of this. For instance, if a PLA filament asked for 200 degrees, you may vary the temperature from 190, 195, 200, 205, 210 (the default values of the form). Typically, the first layer temperature will be elevated to increase adhesion with the bed, especially if a lower than usual temperature is being trialled for segment A.

@@ -1084,7 +1084,7 @@

For initial tests, you can leave the retraction speed at 40 mm/sec. For a bowden tube printer, 6mm is a likely retraction distance. For direct drive, a starting value of 1mm may be suitable. If you are following this guide in order, you should already know your ideal retraction values.


-


+

Base feedrate/speed

You can specify the feedrate for X and Y movements. The inner perimeter will be set to this speed and the outer perimeter 50% of this speed.